Model

NBD-G1200-26TI2F-350

Electrical Spec.

Three-phase 380V 50HZ

Tmax

1150℃

rated power

12KW

thermocouple

Type K thermocouple 420mm

heating-zone size

φ350*420mm

310s stainless steel pipe

70L

0~11R/min

0~19R/min

L1430×D1060×H2560mm

Recommended heating rate

Main control interface

1,  sintering process curve setting: dynamic display setting curve,  equipment sintering can prestore multiple process curves, each process  curve can be set freely;
2, can be reserved sintering, to achieve unattended sintering process curve sintering;
 3, real-time display of sintering power and voltage information and  record sintering data, and can be exported to achieve paperless  recording;
4, with remote control, real-time observation of equipment status;
 5, temperature correction: the difference between the main control  temperature and the sample temperature, the whole sintering process for  nonlinear correction.

Temp. Accuracy

+/- 1 ℃

You can log in to the control system anytime and anywhere through computers, mobile phones, and other terminals to view the operating status of the heating furnace (temperature, pressure, heating rate, etc.), and remotely adjust parameters and start/pause programs according to experimental needs. No need to travel back and forth to the laboratory at night or on holidays to meet the parameter tuning needs during the experimental process; Real time monitoring of key experimental processes can also be achieved during cross regional business trips, significantly reducing ineffective commuting time and allowing researchers to allocate work energy more efficiently.

High definition working chamber quartz viewing window

Pressure measurement and monitoring

The  mechanical pressure gauge with damping oil is used to make the pressure  fluctuation produce damping and reduce the pointer swinging back and  forth.

gas supply system

The  float flowmeter is used to control the gas flow rate, which is  integrated with the equipment, and the leakage test has been carried out  before the factory.

Approx.650KG

Cautions

1.  When the equipment is used, the absolute pressure gauge reading should  not be greater than 0.15MPa to prevent equipment damage caused by  excessive pressure;

2. When used under vacuum, the operating temperature of the equipment shall not exceed 800℃.

Service

1 year warranty with lifetime support (warranty does not cover consumable parts such as furnace tubes and seals)